Under-Workbench Storage That Actually Fits

Got wasted space under your Husky workbench? Here’s a simple rolling bin build that turns that low, awkward cavern into practical storage—without buying new lumber.

What you’ll get: a tight-fitting rolling box, lessons learned on trimming for clearance, and tool tips to speed assembly.

Plan the footprint, not just the measurements

• Start by sizing to your actual opening under the Husky 62” workbench. If tolerances are tight, measure with the piece after the cut rather than only a tape. Test-fit early so you can adjust before full assembly.
• A 30” x 30” target can work, but caster height and side thickness add up fast. Dry-fit the base and one side, then confirm wheel clearance.

Build from shop scraps and adjust on the fly

• A half-inch OSB base with 3/4” plywood sides is plenty for a rolling bin. Rip panels on a Ryobi Tablesaw or break down with an M18 Milwaukee Circular Saw.
• If it binds, don’t force it. Pull a side, trim the base and both side panels evenly, then reassemble. In this build, removing 3/4” across the base and both side pieces solved the fit.

Fast, sturdy joinery for a shop bin

• Use the Kregg Pocket Hole Jig for strong corners you can disassemble if needed. Tack sides with a Ryobi Brad Nailer to hold alignment before driving pocket screws.
• After the refit, reattach casters to the base. Keep fasteners away from wheel plates so you’re not forced into awkward offsets.

Final fit, finish, and handling

• A simple handle makes all the difference. Center it on the face so you can pull the bin straight and it seats fully under the bench.
• Knock down sharp edges with a Ryobi Palm Sander. Ugly is fine; function first for shop storage.

Takeaway: Build the rolling bin to the opening, not the drawing. Test as you go, be ready to trim, and you’ll end up with under-bench storage that slides in clean and works every day.